After all, there are many roads to Rome, and the most convenient shortcut is to be born in Rome
.
For places with small area, you can also choose the method of manual brushing, but also ensure the flatness of the coating
.
After the coating is finished for the last time, it can be put into use again after 7 days of natural curing
.
It should be stirred evenly enough and used after curing for about 15 minutes
.
After the last finishing coat is applied, it can be used after 7 days
.
Knowing these tips of epoxy floor construction can help us build an epoxy floor faster and better
.
Before using the coating, it must depend on the production date and shelf life
. Fixing Socket Cross Hole Nail Plate
after treatment, the metal surface shall be kept dry, and the coating can be carried out within 4 hours
.
Just like the construction of epoxy floor, using some tricks can get a high-quality epoxy floor faster and better
.
In addition, the floor construction needs the accumulation of experience, so let’s start now
.
This does not mean that those who were not born in Rome can not work hard, but to find ways to find the fastest way to Rome
.
Preparation method: mix the coating evenly to ensure that there is no precipitation at the bottom of the barrel, and mix the coating and curing agent in the proportion of 10:1
.
Do not pour the remaining primer into the original coating, which will pollute the original coating
.
If the paint is too viscous, it can be diluted by adding appropriate special diluent
.
Coating method: it is best to use high-pressure airless spraying, so as to make the coating more flat
.
If it exceeds the shelf life, it is best not to use it, so as to avoid poor effect and waste
.
In winter, the temperature is low, and the proportion is changed to 4:1 for mixing
.
。
.
Service life: for the prepared coating, it is recommended to use it up within 2 hours when the temperature is about 20 ℃, so as to achieve the best effect
.
Many people say that “there is no shortcut to success”, which is not impeccable
.
Surface treatment requirements: when painting the metal surface, the surface shall be cleaned first, such as sand blasting, rust removal, etc
. 
The tools shall be cleaned with special diluent after use
.
