Although its area is small, it brings together three important projects: Waterway, circuit and waterproof.
Some people mistakenly think that there is a waterproof layer in the original, isn’t it better to do it again? But in fact, this idea is wrong.
Because there is often ponding in this, too smooth ceramic tiles can not be used.
Share every day.
Please rest assured.
After staying for a long time, there will be leakage with the aging of the colloid around the waterproof strip.
Graphic source network, infringement contact deletion! When decorating the bathroom, we pay special attention to it.
So before we lay bricks, we should remember to buy them in advance and ask the master to make them embedded.
In this way, the master can only install the water retaining strip on the ceramic tile and can not be embedded into the cement layer.
The floor tile has no skid resistance.
Therefore, the pit distance must be measured before purchase.
Don’t wait for an accident to regret…
You should have a number in mind before decoration.
Therefore, in order to avoid this situation, it is best to roughen the wall before formal paving to increase the roughness of the wall, so as to avoid the risk of brick falling off in the future.
5.
The water retaining strip is not embedded in ceramic tiles.
1.
The original waterproof has not been eradicated.
In this way, it will not play the role of water retaining in the later stage, and the accumulated water will spread to other areas.
However, we should pay attention to this kind of waterproof wall when pasting bricks in the later stage.
Since the waterproof coatings are relatively smooth after drying, if the tiles are paved directly with cement, the tiles are likely to fall off.
After painting the waterproof wall, paste bricks without roughening, such as shower area or light partition wall.
We often ignore this water retaining strip during construction.
2.
It was purchased late.
Therefore, during construction, the original waterproof must be removed first, and then the new waterproof must be made.
If we do not measure it in advance when buying furniture, the general size deviation will not be too large.
Especially if there are old people and children at home, pay more attention.
The floor of the toilet is different from that of other spaces.
Many people at the door of the bathroom know that a doorstone should be made to block water.
6.
Otherwise, it will increase the risk of falling in the future.
Generally, the commonly used sizes are 300, 400, 450mm, etc.
However, some friends do not know that in fact, a waterproof pier should be made under the lintel.
Before reading this article, please click the blue font above, and then click “follow”, so you can continue to receive the latest articles for free.
3.
Don’t regret it until you check in.
There is no waterproof pier at the door.
The displacement device needs to be used in the later stage, which is easy to cause problems such as blockage and backflow.
So we must pay more attention during construction.
Because we don’t know the brand and model of the waterproof coating we made before, it may not be the same as that purchased later.
Before buying the toilet, the pit distance is not measured.
Although we have to waterproof the wall and ground during construction, some new house developers have made waterproof for us.
If the original waterproof layer is not removed, the fusion of the two coatings may produce some reactions, thus reducing the effect of new waterproof.
Especially in these six places, making a mistake will be a big trouble.
4.
Generally, we will make the waterproof slightly higher.
Because it has pit distance requirements, if it is not measured before, the toilet bought back may not be installed.
Otherwise, the accumulated water under the ceramic tile will seep outside the room through the cement layer.
Therefore, during construction, we must remember to ask the worker to install a waterproof pier.
But the toilet is an exception.
It’s a free subscription.
