Scrape and flatten the putty first with a scraper, then level with an aluminum alloy scraper, and then polish with sandpaper and spray water for maintenance, Make the putty surface smooth 03.
Next, brush the split line paint, snap the line with the fixed-point ink bucket of the horizontal pipe, and then trace the joint with the water-based paint pointing paint 04.
Spray the colorful imitation stone main color paint, paste the textured paper according to the split joint before spraying, and then spray evenly 05.
When spraying, spray it evenly from top to bottom in the same direction to achieve a flat and natural imitation stone effect, which can not be repeated After the over spraying surface coating is completed, quickly remove the textured paper to avoid affecting the segmentation effect, check the finish and conduct local treatment.
If you find it useful, please share it with your circle of friends, It can not only increase professional knowledge, but also help more people..
06.
The dry goods brought to you today are the construction process of water in water.
Apply alkali resistant sealing primer to seal the cured base surface.
Base surface treatment: firstly, the wall surface shall be accepted, and the treatment of base surface shall be flat, If it is dry and there is no depression, if it is rough, it must be repaired and polished before construction.
This step can close the pores of the base surface and isolate water vapor, Enhance the adhesion of the colorful paint.
Due to the large number of uploaded dynamic drawings and large files, the articles previously edited in word can not be imported, and they are typed again manually.
OK, next, let’s get to the main topic…
Spray the colorful imitation stone surface coating, which determines the overall tone and final decorative effect.
It is recommended to apply it evenly by spraying or roller coating.
After drying, the finish can be protected from water and pollution.
Brush the water-based dust-proof finish immediately after the surface coating is dry.
02.
“Construction process of water in water” ▲ structural drawing of finish of water in water construction 01.
Before construction, paste the beautiful paper again along the split joint Corrugated paper put the water in water coating into the pressure spray tank.
Finally, clean the site.
