What should we pay attention to when the new square column buckle reinforcement is used in construction?

02.

Then reinforce with fixed steel strips, and the spacing between fixed steel strips is 30-50cm.

The adjustable square column formwork reinforcement only needs two people to reinforce the building formwork of the opposite column conveniently.

Here is a brief introduction to some problems that should be paid attention to during installation.

The fixed steel belt nuts installed up and down shall be aligned in reverse.

The formwork shall be installed in dislocation.

Click the text above to pay attention to our} new square column buckle.

03.

When installing the steel belt of square column buckle formwork, measure the formwork with a steel ruler and install it horizontally according to the specified spacing distance.

Magnetic Steel Chamfer

04.

Due to its own advantages, it has a wide range of applications in construction and other aspects.

The square column formwork shall be installed in dislocation according to the length difference between the opposite equal length and the adjacent buckle two sides.

When installing and fixing steel strips in sequence at a spacing of 30-50cm, the upper and lower steel strips shall be fastened with sector nuts, and the upper and lower steel strip nuts shall be arranged in reverse alignment.

01.

When installing sector nuts, the tightening degree of each sector nut shall be consistent.

The last steel strip nut corresponds to the next steel strip corner, and the next steel strip corner corresponds to the next steel strip fastening nut, which can be installed in turn…

Place the two clamping plates opposite to the center of the built square building formwork, then set the upper limit sleeve, select the corresponding fixing hole according to the size of the square column, and insert the fixing pin to complete the installation of the fastener.

The adjustable reinforcement can meet your columns of various specifications, solve the problem of strengthening the formwork, save the time of installing and strengthening the square column, shorten the construction period and save the cost.

Install steel belt at the formwork interface.

The high-quality refined steel used for the reinforcement of square column fastener has strong compression resistance, not easy to deform, simple installation, easy to learn, no slippage and no slurry running.

The bottom plane of square column formwork shall be 0.5-1cm away from the ground and filled with concrete.

Steel belt shall be installed horizontally.

A steel belt shall be installed at the upper and lower interfaces of the square column formwork, and it shall be horizontally covered and reinforced at the interface to maintain the vertical and lateral pressure borne by the square column formwork when pouring concrete.